compression test, and couple other questions...

[THEFERMANATOR]

Originally Posted by step up here

jasper has a very good name in automotive and marine

JASPER has a horrible reputation in the industry if your on the side of it I am. The only good thing they have going is there warranty. I couldn't tell you how many of there engines and trans that I have heard of being DOA at the dealer, then the dealer gets heat from the customer for it taking so long whne it is actually JASPERS piss poor work that was the problem. I've seen inside some of there remans, and I sure wasn't impressed. Then again I am known as a bit of a perfectionist(spent most of the day doing head gaskets on a 25HP KOHLER because I didn't think the block was flat enough, so I got out a flat block and some 320 and went to work resurfacing the block on the mower).

[Rollin Thunder]

Originally Posted by THEFERMANATOR

JASPER has a horrible reputation in the industry if your on the side of it I am. The only good thing they have going is there warranty. I couldn't tell you how many of there engines and trans that I have heard of being DOA at the dealer, then the dealer gets heat from the customer for it taking so long whne it is actually JASPERS piss poor work that was the problem. I've seen inside some of there remans, and I sure wasn't impressed. Then again I am known as a bit of a perfectionist(spent most of the day doing head gaskets on a 25HP KOHLER because I didn't think the block was flat enough, so I got out a flat block and some 320 and went to work resurfacing the block on the mower).

I agree, but The boat needed a new engine and I wasn't willing to pony up 7-8k for a new crate motor when I new I was going to sell it. Took 3 engines from them to get it right.\\

Hey just curious. How did you get your tahoe to burn rubber like that. I have an 07 and for the life of me (even if I turn the TC off) She wont do it. I have been told by my buddy its all the torque management GM puts on their trannies. Neat picture though!

[RWilson2526]

Originally Posted by Rollin Thunder

Hey just curious. How did you get your tahoe to burn rubber like that. I have an 07 and for the life of me (even if I turn the TC off) She wont do it. I have been told by my buddy its all the torque management GM puts on their trannies. Neat picture though!

Oh that aint no regular truck...I think he added a flux capacitor!

[willy]

To Spare's point, three Jasper 350 Chevies in a row. Each engine had issues, serious issues and they stood by it and replaced it, the problem is eventually your mechanic gets a little tired installing three engines in a row.
These were their top of the line level rebuilds by the way.
Crap

[THEFERMANATOR]

Originally Posted by RWilson2526

Oh that aint no regular truck...I think he added a flux capacitor!

And a warp drive while I was at it. It's a 95 BURB with a few add ons to her. Need to update the thread a bit as I've done some more to her since.

http://www.wellcraftv20.com/communit...ad.php?t=11664

[Rollin Thunder]

a few add on's he says. Awesome build man. If you dont mind I shared it on a tahoe forum I frequent. They should enjoy it.

[Rollin Thunder]

hey guys. I got the results back on the compression test. 145 for cylinder one and 140 for 2, 3, and 4. Are these good numbers for a 3.7 liter? Everything else got fixed too. All done for 300 bucks.

[step up here]

thats very good and he took care of the alternator too sounds like a good price


hope your buyer is satisfied. if so you just experienced the two best days of boating the day you bought and the day you sold it. amen!