|
|
|
|
#1
|
||||
|
||||
Hey reel. In thinking back and looking at the pics. I think what I did on the rubber cap was drill a hole first for a tight fit on the wire diameter. Then I made one slice with a utility knife across the hole for the plug end. The once it's pulled down tight, the slice fits back together evenly. Probably would hurt to smear the top of the cap with some goop like your thinking afterward.
I think I'm going to use this method in the new Scout (if it ever gets finished and I can bring it home....  ).
__________________
Heavily medicated for your protection. 
|
|
#2
04-23-2010, 06:26 AM
|
||||
|
||||
|
Quote:
Thanks for the idea...and I believe "Message Sent!!"... 
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#4
04-23-2010, 05:19 PM
|
||||
|
||||
|
Quote:
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
