|
|
|
|
#1
|
||||
|
||||
I like the blue hull!! Nice work guy's!!
Have you looked into a extension kit for making your motor a 25"?? From what I have seen on most kits, its just a spacer and a longer rod and water tubes, If they make one for your motor that might be the way to go? Good Luck!
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#2
02-12-2010, 05:58 PM
|
||||
|
||||
|
the shift rod is going to be the stickler on the extension kit, I gotta do soem research. Ferm, Skools, what kind of ideas ya'll got
|
|
#3
02-12-2010, 06:18 PM
|
|||
|
|||
|
Before I found my V w/ the 20" transom, my plan was to use the jackplate method. I think that as long as you are carefull not to tilt it up too far it will work.
Of course the ideal setup would be a hydraulic jack plate so you could raise it before tilting up, allowing for FULL TILT.
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
