New here!

[inaforty]

Ha!
Our Rosborough is right around the corner on the north side of the bridge at Whaling City Marina. Not sure if we going to spring for a slip for the Wellcraft. Would be much easier then trailering it but then I would have to apply new bottom paint and zinc etc. The wife is all for it but I'm going to have to come up with the cash.

Should be a hell of as time this summer at the Seaport. I would imagine they will have the outdoor Tiki Bar open. Seems they had it setup last year but never open it. I wonder if they had trouble with permits etc. I notice that the Seaport is rebuilding the seawall.

[inaforty]

Got some more work done on the boat. Removed the bail mounts from the previous owners electronics and filled the holes in the dash.




Couldn't get the Garmin 192 to mount in the same location on the dash as the previous electronics due to the internal GPS antenna on top of the Garmin unit. So I built a little box out of starboard to mount the unit on the right hand side of the dash. Came out pretty good and cheaper then a RAM mount.


Also installed the doors to the cuddy/V berth.


I'm going to toss out the old bail mounts. Not sure what they are for but if anyone has any use for them let me know and I'll send them out to you.

[RWilson2526]

nice job staying at it....supposed to hit 45 F here today....planning on pulling back the tarp and getting a little done myself.

[racrx7]

Doors look fantastic!! What did you put on them to make them look so rich?

[inaforty]

The wood was a mess when we got the boat. I sanded everything down then went with 6 coats of Helm'smen by Minwax. Not the best stuff to use but it came out OK. I had a good portion of a gallon left over from doing the wood on our Whaler.