|
|
|
|
#1
|
||||
|
||||
I not worried about the motor cause at you say its all plug & Play, itys all the other crap I have to clean up!! I have to rip everything out EVERYTHING!!
And rewire all new, radar, GPS, FF, lights, pumps, salt water wash, all the other stuff. Is going to be a pain, But I have BS and CB to help me, I hope?? We are all buying new stuff that we are all going to be hard at work come spring fixing are own stuff!!.
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#2
12-28-2009, 03:44 PM
|
||||
|
||||
|
All new stuff Macojoe!
WOW that sound like fun! All that other crap....like this.  Here is the wiring all reworked so that everything is easily accessible etc. I'm no pro installer but I'm much cheaper and when something goes wrong I know where to look. I turn the battery on after everything was completed and the only thing I missed was one ground going to the in dash depth finder.  
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;)
|
|
#3
12-30-2009, 09:17 AM
|
||||
|
||||
|
Nice work, looks tons better. I will try to post some pictures of the switchplate, and terminal blocks I got to do from scratch for my center console. I like to use some electrolitic grease on all terminal ends to slow down corrosion and solder with heat shrink when the wire is fresh and new.
MJ posted about seized switches from Blue Sea? WTF? I never seen that one. They normally sell some nice quality stuff.
|
|
#5
12-30-2009, 11:31 AM
|
||||
|
||||
|
looks good, inaforty, i had to do pretty much the same thing, i also moved the fuse blocks and ground block outside the dash cavity. i relpaced the orignal canvas cover with one that was large enough tocover the new blocks outside on the cabin roof. it dosen't really do anything, justlooks neater.
|
|
#6
12-30-2009, 05:31 PM
|
||||
|
||||
|
Phat,
I like the idea of making a larger canvas to cover the fuse block/ bus bar mounted outside the dash cavity. I would like to do something like that. I was thinking of making some sort of cabinet but that would probably take up to much space. Like the idea of just a larger canvas. Did you move the snaps mounted to the V berth ceiling. I think I still have my Dad's snap installer that mount on the jaws of vise grips. Now I just need to clean the mold out of the monkey fur. Anyone have any tips on cleaning the monkey fur?
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;)
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
