New here!

[inaforty]

Been working on the woodwork. I had almost a full gallon of Minwax Helmsmen so I used that. I looked at the Sikkens products but at $109 a gallon I thought I would just put a few extra coats of the cheap stuff. Something to keep me busy with all the snow on the ground outside.

[lumberslinger178]

looking good ...... take lots of pics

[reelapeelin]

Thanks for all the pics!!...good work on the teak...and may I say, "Nice shop!!"...

[nipper]

Looks terrific in a 40. Yeah, the Sikkens is expensive, but a quart goes a long way. I about cried last year when I knocked over an open, almost full quart in my garage. $40 down the drain and a permanent stain on the garage floor!

[inaforty]

Nipper,
I might regret using the cheap stuff but the V 20 will probably get limited time on the water next summer. However I might be under estimating the allure of the V 20 as a fun day boat and leave the Rosborough tied up at the marina.

[nipper]

I think you will be fine with it. As is evident from the pix of your work, you prepped the wood very well which is the key. Hard to beat the look of a nicely prepped and varnished teak.

[inaforty]

We had a few nice days last week and got to work on the boat. Cleaned up the mold and mildew in the monkey hair. Came out pretty good considering how bad it looked when we started. Just need to go over the monkey hair with Resolve carpet cleaner to remove the stains from the glue use to apply the monkey hair to the ceiling of the V berth.

Installed the V berth teak and the teak strips for the sliding hatch along with the fiddle sticks on the dash. Haven't installed the V berth doors yet because of a crack in the gel coat. Seems the boat might have been a victim of theft at some point by the looks of the damage.

Few photos










Got the steering cable out of the boat (had to cut it at the motor). Everyone was correct..the motor will have to be removed to install the new steering unit and cable. The cable and steering unit was original with a date of Nov 1986. Looks like I'm at a point where I will have to wait for warmer weather to do the steering installation. While I have the motor off I would like to seal the transom under the aluminum trim. I removed an old transducer from the boat an didn't see any water dripping. Might have gotten lucky and have a solid transom.