Antennas...

[Blu_Lunch]

Am Fm antenna will not interfere because you can't TX on them. Remember every 3 DB of gain, you double your ERP {Effective Radiated Power} of your radio. Hams are always willing to help out, use The QRZ database to find someone . I case your wondering QRZ in the old amateur radio Q signal's that date back to Morse code days stands for "Who's calling me"

[THEFERMANATOR]

ALL of the 2000CC's origanally had an antenna mount on the starboard side right up next to the fuel filler. This was standard equipment from HYDRA-SPORTS. As for the VHF and AM/FM, get one of the newer VHF's that has a radio built into it. I seen that they came out not too long back and use one antenna I believe and they simply switch to which one you want to use unless there is a DSC signal and then it automatically goes to VHF. Or you could simply hook your AM/FM radio up to your grab handle by the windshield and use that as your antenna. This is the same antenna arrangement that most boat builders use now in fiberglass boats.

[Bygracealone]

Originally Posted by THEFERMANATOR

ALL of the 2000CC's origanally had an antenna mount on the starboard side right up next to the fuel filler. This was standard equipment from HYDRA-SPORTS. As for the VHF and AM/FM, get one of the newer VHF's that has a radio built into it. I seen that they came out not too long back and use one antenna I believe and they simply switch to which one you want to use unless there is a DSC signal and then it automatically goes to VHF. Or you could simply hook your AM/FM radio up to your grab handle by the windshield and use that as your antenna. This is the same antenna arrangement that most boat builders use now in fiberglass boats.

Ferm, I looked where you said and I don't see where it was originally. Here's a pic:

[THEFERMANATOR]

SOmebody has filled in the holes on it then because the antenna was standard equipment from HYDRA-SPORTS right on top of the gunwale by the fuel filler. Both of mine have the mount right on top there.

[Bygracealone]

Originally Posted by THEFERMANATOR

SOmebody has filled in the holes on it then because the antenna was standard equipment from HYDRA-SPORTS right on top of the gunwale by the fuel filler. Both of mine have the mount right on top there.

Ferm, you know, it's weird because I also understand that trim tabs were standard equipment on the Vectors as well, but I don't have them. There may be holes there that I can't see because filled in and covered over by bottom paint, but I wonder what's going on with my Vector. It has the Vector decals on it along with the full length lightning bolt along the side... ???

WRT the antenna mount, if there were holes that were filled in, they did a great job because there's no evidence at all that there were holes there. I'm not saying it's impossible, just that if it was done, it was done right.

[reelapeelin]

BGA...if you have to find a new place to mount your antenna (s), may I suggest...if it will fit there, mount it just outside where the Bimini's main rail mounts to the top of the gunwale...that way you are not ADDING a new obstruction point as you would if say it was mounted in front or behind the top.

Does your Bimini mount top of the gunwale or inside?...there may not be enough room for this if it is top mounted...good luck whatever route you decide to take...and of course PICTURES

[THEFERMANATOR]

I put my 2 on the console and face them slightly forward, they look a bit odd but work fine. They also clear my bimini top with no problems, but your top may be mounted differently than mine.