|
|
|
|
#1
|
||||
|
||||
usually when you have a bennet that won't retract, either teh line is crimped or the hose nipple is threaded in too far on teh cylinder. Loosen teh fitting on the hose niple for the tab that won't retract, if it comes up, its in the line or the pump, if it doesn't, trun the hose nipple about two turns out and see if it raises. If you install teh hose nipples too far in the bennert cylinders, it will cover the transfer hole to the cylinder, it will let fulid by under high pressure, but it won't let it out
|
|
#2
08-15-2009, 11:24 AM
|
||||
|
||||
|
Curious as to which would be better: Bennett M120's or the traditional 12x9's? Do any of you have experience or opinions about the differences?
M120's: http://www.rivermarinesupply.com/xca...substring=m120 12x9's: http://www.rivermarinesupply.com/xca...er_Switch.html
__________________
 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/
|
|
#3
08-15-2009, 09:37 PM
|
||||
|
||||
|
Quote:
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
