My current project

[THEFERMANATOR]

I guess I've been slacking on updating this one. I got to driver today and feel her out a bit and the power of the DMAX is SWEET in this SUB. It has more power with 3.42's in it than my 6.5 EVER had with the 4.10's. I have run into a few bugs that have to be ironed out though. I'm leaving on my honeymoon on WEDNESDAY, so thankfully I have a back-up vehicle for my trip.

First off the heater return pipe from the heater cores to the lower radiator hose developed a leak in it right at the weld for the retaining arm.


So I'll have to get a new tube for when I get back. Also I have 2 codes that won't go away that I can find no reason for, P0748 and P0778. Also I have very little power in 1st gear and lots of blue smoke if I giver her more than about 20% throttle. This only seems to happen in 1st as 2nd and 3rd pulled VERY strongly. Also my tow/haul mode isn't functioning properly as it gives me VERY hard shifts when engaged and holds them out ridicuously long and provides NO grade braking what so ever. I wasn't able to get her up fast enough where I was driving to test out the OD/LO function.

The A/C doesn't engage for some reason so I'll have to do some digging tommorrow with EFILIVE and see if I can figure out why the ECM isn't commanding the A/C relay(A/C works when I jumpered it).

Heres a pic showing the TCM and you can see the ECM as well tucked in by the drivers side battery tray.


I haven't finished up the airbox yet, so for now the filter is just laying in there.


Another engine bay pic.


And a pic of the front end with my projector headlights. I did have the grill and such on it, but had to take it back off to get to the bolts that hold the drivers battery tray in place.


Hopefully I can get ahold of Brayden before I leave and get his opinion on what to check for the 2 codes and also about low power in 1st as I think it is a torque management issue.