|
|
|
|
#1
|
|||
|
|||
My motor now turns. It took about 2 hours of manipulating it and spraying penetrating oil in it until it was free. Then I was able to put a whole bunch of grease in the tube and turned the wheel to work the grease all the way through. I appreciate all the input and advice from everyone. It would have taken me a lot longer without your guidance.
Thanks Carl
__________________
1978 V-20 Steplift 1988 Mercury 150HP 
|
|
#2
05-20-2009, 09:32 AM
|
||||
|
||||
|
Carl, any particular advise that seemed to help the most? Like Steplift20's wrench comment? Did you have to beat or heat on it?
__________________
 1994 Wellcraft V21
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
