|
|
|
|
#1
|
|||
|
|||
Here is a picture of RABUDS installed on a boat in the gallery (little scupper next to the bracket) these look to me to be installed to high and above the deckline, which would not drain. They are basically a scupper with a ball stop to eliminate any backflow in installations like my V-20 where the transom water line will dip when not under way with weight, swell etc. I understand the load issues and marking, was hopeful that someone else has dealt with this and has some tips learned through their experience. In my area we take a lot of water spray while under way. I do not like the that the deck does not self bail. Want to fix that.
|
|
#2
05-05-2009, 07:01 PM
|
||||
|
||||
|
'85 shoulda had floor drains...are they there?...if so, you'll have to PIPE them to your new Rabuds if I remember the set-up correctly...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
