|
|
|
|
#1
|
|||
|
|||
I have a venerable 1978 Wellcraft V-20 and am considering installing a transducer that mounts inside the hull. Can anyone offer advice?
Last edited by cspinosa; 05-05-2009 at 10:15 PM. Reason: clarity 
|
|
#2
04-30-2009, 05:53 PM
|
||||
|
||||
|
On my 1986 outbd & 1990 inbd both have a flat area about 16-18" fwd of the transom in the bottom bilge area. Some boat dealers installed the bilge pump in this area because it is flat. This area is suppose to have been made with no wood or air bubbles so a transducer could be installed. Check yours.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
|
#3
04-30-2009, 06:16 PM
|
|||
|
|||
|
I run two on mine with no problem, the ducers are mounted one on each side.
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
