|
|
|
|
#1
|
|||
|
|||
They should work fine as long as they are not the same frequency . Do you plan to mount them on the transom or glue the transducer inside the hull ?
__________________
1994 V20 Fisherman & 2004 Yamaha 150 
|
|
#2
03-31-2009, 06:07 PM
|
||||
|
||||
|
He plans to mount them on the transom about 10" apart. He called Cabelas today and their tech said there should not be a problem. He'll find out in the next week or two. Thanks Billy Mac
__________________
 Now being pushed with the Force of an E-Tec! http://www.wellcraftv20.com/gallery/...1990-V20-Sport http://www.youtube.com/watch?v=9ESnJm4uxug
|
|
#3
04-01-2009, 08:36 AM
|
|||
|
|||
|
That should work . I mounted my last transducer inside the hull with epoxy and it works well. The diadvantage being a loss of the water temp. . Good luck ....
__________________
1994 V20 Fisherman & 2004 Yamaha 150
|
|
#4
04-30-2009, 04:21 PM
|
|||
|
|||
|
I have a venerable 1978 Wellcraft V-20 and am considering installing a transducer that mounts inside the hull. Can anyone offer advice?
Last edited by cspinosa; 05-05-2009 at 10:15 PM. Reason: clarity
|
|
#5
04-30-2009, 05:53 PM
|
||||
|
||||
|
On my 1986 outbd & 1990 inbd both have a flat area about 16-18" fwd of the transom in the bottom bilge area. Some boat dealers installed the bilge pump in this area because it is flat. This area is suppose to have been made with no wood or air bubbles so a transducer could be installed. Check yours.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
|
#6
04-30-2009, 06:16 PM
|
|||
|
|||
|
I run two on mine with no problem, the ducers are mounted one on each side.
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
