|
|
|
|
#1
|
||||
|
||||
Here's a trick: Use your knee when you are putting it back in place to help hold it up while you are aligning it and push it into place.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
|
#2
03-13-2009, 12:59 PM
|
||||
|
||||
|
On an ALPHA to do the water pump it is pretty much the same as a MERCURY outboard. You don't have to pull the whole outdrive off, just drop the lower from it. You have to remove the trim zinc to get to the hidden bolt, and make sure it is in forward before dropping it. Also drain the lower before you drop it down as the upper and lower use the same oil and you will have a mess if you don't drain it first. Also make sure and install a complete kit with base, and don't forget the little square o-ring that goes into the lower for the oil passage.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#4
03-13-2009, 05:33 PM
|
||||
|
||||
|
ya'll beat me to it.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
CY 1984 V20 STEP LIFT I/O 470 MERCRUISER Wheeling, WV
Hybrid Mode
