|
|
|
|
#1
|
|||
|
|||
I am not sure what motor yet as I will probably repower. I am definately going to fill in the back transom as you suggest. I was thinking about Nidacore for the bottom half of the transom and bringing it up to 25 for strength then I would imagine ply and glass above that or could I just pour the whole thing but that might be to expensive and heavy and I would have to glass it anyway. Any suggestions would be greatly appreciated.
No, that was not me asking about the tank. I have a 78 cuddy and I actually have a 25 gal. reserve under the main floor panel between the front seats. 
|
|
#2
02-08-2009, 01:03 AM
|
||||
|
||||
|
As long as the transom area were the motor is going to be is all solid I am sure you will be fine with ply and glass.
A cuddy is much better for this conversion as they are a bit bow heavy any way.
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#3
02-08-2009, 11:12 AM
|
||||
|
||||
|
Quote:
I would be VERY LEARY about redoing a transom using two different materials...Nidacore on bottom and wood on top sounds like a combo for problems down the road...I'd chose one material and go w/that, top to bottom...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
