|
|
|
|
#1
|
|||
|
|||
Quote:
Thats good enough, I just have to put on my thinking cap to see if it will work out.
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke. 
|
|
#2
12-19-2008, 10:54 AM
|
||||
|
||||
|
oops... guess I used the rubber ruler. Actual outside to outside is 42 1/2". Inside is 36". The more I think about it that seat could actually work. It would sit in between the storage boxes on the sides, As the splash well sticks out just less than 12" I think the back would recess into the well and finish about 2" or so behind the storage boxes. Would need to install a support across the well to catch the back of the seat. Might be a little loud back there and maybe wet!. just rambling
__________________
1986 V-20 1986 Yamaha 150 HP Last edited by RWilson2526; 12-19-2008 at 12:06 PM.
|
|
#3
12-19-2008, 02:07 PM
|
|||
|
|||
|
I envision putting two pedistal seat type bases on the bottom of the seat at a width that you could mount receivers in the front inside corners of the splashwell. This would allow for easy removal.
My other vision is to use a piano hing on the front of the splashwell lip and attach it to the seat so it can fold out of the way for motor tilting. As for noise, you can cure that with a Johnzuki 4 stroke motor. 
__________________
*************************************** Stay Safe! Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
