FERM and any other Jeep guys......

[Skools Out]

Chrysler Code Retrieval

Accessing Trouble Codes
96 & later are OBD2 & requires an OBD2 scanner.

Code retrieval can be accessed by the ignition key or by a diagnostic readout box(DRB).To obtain the codes using the key method,set the park brake,and put the vehicle in Park/neutral.
Some 95 and later OBDII vehicles, you may be able to retrieve OBDII codes with this procedure, if equipped with digital dash.

• Turn the ignition key ON,OFF,ON,OFF,and finally ON again(ENGINE NOT RUNNING)
• The codes will start to flash on the POWER LOSS or CHECK ENGINE light.
• FLASH,pause,FLASH,FLASH=code 12

Clearing Trouble Codes

Diagnostic trouble codes may be cleared by disconnecting the battery ground cable for at least 20 seconds.
OBD2 vehicles require a scanner to clear the trouble codes.

this may help look threw this site

http://www.troublecodes.net


Here's the codes for your Jeep

http://www.troublecodes.net/chrysler/jeep.shtml



.

[C YENSEN]

thanks Skools, but the key thing did not work again. I have disconnected the battery and I will let it sit for a few hours. We will see it that clears it.


Missed you around here buddy...glad you are back

[THEFERMANATOR]

Yep, like the instuctions SKOOLS posted, it don't work on all of em unfortunately. I know when I was at the dealer it would get frustrating waiting on the DRBIII to read codes, but the key trick didn't work but half the time(if you were lucky).

[C YENSEN]

well i just reconnected the battery after an hour and the light is OFFand it better stay that way

[tsubaki]

I give it less than a week. If you drive it almost every day.

[THEFERMANATOR]

If the light is off after a reset, then start it up. If the light doesn't come on right away then you have a problem in an OBDII monitored area. Many codes will not set until you drive it for 20 minutes at highway speeds.

[C YENSEN]

i figured it will come back on.....hopefully not until I sell it