|
|
|
|
#1
|
|||
|
|||
I have a flywheel removal tool. I'll be going through RI on Tuesday if you want to borrow it for a few hours :) I'll bring a couple of stators too. It's EZ to swap them out.
|
|
#3
06-02-2008, 08:42 PM
|
|||
|
|||
|
bigshrimpin you are the man
__________________
love to fish
|
|
#4
06-03-2008, 09:09 PM
|
|||
|
|||
|
just to let every1 know that doesn't know on this site, Tim (bigshrimpin) really is the man. we met up and he helped me out tremendously today. and he wouldn't take anything for it! he's a really good guy and he knows his mercs.
|
|
#5
06-03-2008, 11:31 PM
|
|||
|
|||
|
Let the truth be told . . . I show'd up at Steve's place with a bad stator (not on purpose) and he got to work with the manual . . . .while I stripped a v20 bare in CT (that belongs in the dump) . . . When I made it back though RI . . . Steve was nearly bald from pulling out his hair.
Steve - when you get a new stator . . . This is what you can look forward too . . . Holeshot . . .  Cruise . . .  Work before the fun began . . . 
Last edited by bigshrimpin; 06-03-2008 at 11:40 PM.
|
|
#7
06-10-2008, 02:58 PM
|
|||
|
|||
|
ok i got my stator in and i installed it. both sides are sparking like sons of bit ches but now im getting no fuel to the carbs!
i unscrewed the part at the end of the gas line that goes into the engine .it had alot of pressurized gas squirt and drain out as i loosened it the metal screen filter looked clean. so gas is getting to the engine atleast... what can be holding it back getting to the carbs?? I dont understand the boat would run on 3 cylinder's fine, gas wasn't a problem. please help!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
