|
|
|
|
#1
|
||||
|
||||
F27 is what I used also, but I had ton's of things to fill!! If you have just a few holes I would use marine Tex, it hardens up nice and blends well, heck after a little dirt you never see it! It will shine some also.
F27 will need to be painted as if left alone it will absorb water.
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#2
05-03-2008, 04:32 PM
|
||||
|
||||
|
Cleaned out the holes (where 5200 was) filled with formula 27 let dry and sanded.
Peeled the 2 top pin stripes off, now I just have to get the water line decal off and install new water line tape. Then I'll be ready for installation of the Poli-glo. Heading to Lowes to pick up some new numbers and letters for boat ID (I want as much as possible to look new) and find some stuff to help peel the waterline tape off. Heat gun didn't do a great job on the part I tried but did ok on the small pin stripes. I think 3m makes something if I remember. Then heading to Wallyworld to get a new battery and bilge pmp for the Jon boat. Never a dull moment or moment a boat doesn't cost u something. BOAT = break out another thousand. battery $30.00, motor 1,600, bilge pmp 30.00 nailing the main muff in the boat PRICELESS!!! 
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson 
|
|
#3
05-03-2008, 06:49 PM
|
||||
|
||||
|
use oven cleaner on the striping, do a small section at a tiem, don't let it dry
|
|
#4
05-04-2008, 08:48 PM
|
||||
|
||||
|
ok got a heat gun and got the small pin striping off, haven't tried the large striping at the water line.
Got my teak off and washed and scrubed and sanded, steel wooled it. It's ready for the oil application, will do that tomorrow. filled the holes with f-27 and sanded.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson
|
|
#6
05-05-2008, 04:34 PM
|
||||
|
||||
|
Quote:
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson
|
|
#7
05-05-2008, 06:39 PM
|
||||
|
||||
|
I took off the teak and cleaner and got 3 coats of teak oil on them. I'll check them tomorrow and see if they are dry.
Should I put additional coats on them until they will not soak up any more of the oil?
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
