|
|
|
|
#1
|
||||
|
||||
It looks like up until 90 that either of those would work, but 91 went to the pin style like SKOOLZ talks about according to the BRP catalog. You would need a FASTRAK style if it is a 91 trim and tilt.
Or another option would be to take this unit http://cgi.ebay.com/ebaymotors/ws/eB...MEWA:IT&ih=001 and remove the tilt tube and trim ram pin. And then use the the clamp brackets from it and swap it over to the other engine set-up. The FASTRAK style trim and tilt fetch's a pretty penny even on EBAY used.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
Last edited by THEFERMANATOR; 04-16-2008 at 11:44 PM. 
|
|
#2
04-17-2008, 01:57 AM
|
|||
|
|||
|
Hey Ferm - How much are the fasttrak units going for . . . I have a trim and tilt for a 1995 200 that I need to sell off (actually a complete mid-section). . . would that work?
|
|
#3
04-17-2008, 07:56 AM
|
||||
|
||||
|
Guys, I thought the Fastrak units were for 96 and newer motors
 If I do need a Fastrak, then would this one work?: http://cgi.ebay.com/ebaymotors/OMC-J...QQcmdZViewItem
__________________
 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ Last edited by Bygracealone; 04-17-2008 at 08:08 AM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
