|
|
|
|
#1
|
|||
|
|||
Engine Info I think
Replaced stern drive and engine with 1986 OMC stern drive and Marine Dodge 6cyl engine. Very clean and very quiet though. Stern drive was totally rebuilt three years ago.
There was a little smoke coming from the carburetor though, but I think was steam from a cleaning in the morning if that makes sense. Found a mechanic who can work on it close which I hope I don't need. 
Last edited by v20munch; 04-08-2008 at 01:37 PM. 
|
|
#2
04-07-2008, 09:14 PM
|
||||
|
||||
|
yes you can use slings or just pick it up with the transom eyes and the bow eye.
__________________
 1978 V20 Cuddy w/ 225 Johnson. And Several other boat's
|
|
#3
04-08-2008, 07:45 AM
|
|||
|
|||
|
Boat Lift Slings
SKOOLS OUT-
Thanks Skools Out. Actually plan on storing the boat on a boat lift. Hope she is up to it. No problem so far. General How To- Have some very small rust stains on the hull. Any good product for this which will not damage the gelcoat?
Last edited by v20munch; 04-08-2008 at 01:38 PM.
|
|
#4
04-08-2008, 07:49 AM
|
|||
|
|||
|
Transom Worries
Have not noticed any transom issues but will check closer. Not sure I know how though?
Also, have seen some issues with fuel tanks on the V20. When I have a problem will I just know, or is there something I need to do? Maybe I should just have a six-pack and stop worrying so much..........
|
|
#5
04-08-2008, 05:30 PM
|
||||
|
||||
|
Welcome to the site munch
I have a V-20 I/O with the 350 volvo penta dual prop. I use a product from boaters world in a white and purple bottle for rust removal. I squirt it on and leave it overnite and its gone. It is clear and thick (like naval jelly) but it works great. garage
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
