Transom repair - Here we go..... (long)

[tsubaki]

Started the same thing the same way this week on my gigging boat but gonna pour the assend with glass and cloth like the V.
It's an old "74 Owlcraft.


This made it much easier doing the V and this boat.

A 3"x24"x1/4" piece of flatbar cut on a 45* to finish the scrapeing.
The weight alone does most of the work.

[mauryc]

That 75' is an "easy access transom". That thing I got makes it hard to get it all out - the sides of the transom are so darn high. How's yours held up since the pour?

[lumberslinger178]

murauy are you doing this to the dually???

[tsubaki]

Less than a year since it was done, so no real comparing yet.
Yes the dual should be a lot harder than the cuddy.

[tsubaki]

The thread Still has some picture problems (my fault) but here is some of it.
http://www.wellcraftv20.com/communit...t=specs&page=6

[mauryc]

"murauy". Lumber, what the heck is that????? I know Maury is unusual, but??? :)

Yep, the dually is undergoing surgery. Ordered the Arjay 6011 yesterday so it should be here by the weekend. Because of my schedule, I plan to pour the weekend of the 8th. I'll have the aluminum transom cap made the following week (about $100), then I should be good to go. I've got my fingers crossed, but so far so good.

Maury

[lumberslinger178]

[quote=mauryc;114267]"murauy". Lumber, what the heck is that????? I know Maury is unusual, but??? :)

LOL sorry some times I get excited....