steering cable lenth

[steplift20]

how do you slide the motor? Im going to cut the cable and remove everything i think the steering rod just slides out of the tube im not sure but what i want to do is clean out the tube,i think theres alot of dirt and grease in there making the steering tight and harrd to turn what do you think

[macojoe]

You have to unbolt it and remove screws, then you can slide over after you break the seal from the sealant they added for the screw holes.

You can jack up and slide over or you can lift up and slide over, depending what you have to work with.

Some have been able to switch with out moving the motor but I say 90% have to.

[Bygracealone]

If he's going to cut the old cable, then couldn't he just start the new cable from the back without having to move the motor? Just feed the cable through the gunnel until you're able to put the back end into the tube... Maybe I'm missing something...

[Skools Out]

i notched my hole so i can replace my cable without taking the motor off.

[steplift20]

skool i have the same boat you do and year too

[tsubaki]

Forgot that mine isn't routed like most peoples cable.

[steplift20]

wow well thanks scool 17 feet is the perfect lenth AND i had to take it to the shop because i couldnt get the cable thru the tube so he had to take the engine off and installed a new tube put it all back together and now the steering is perfect
after all these years of fighting the steering wheel its finally perfect but ofcourse when i got it back the trim selenoid went if you se i posted it up but didnt get many replys but i think i know howto get to it but the steering if fixd and thanks for telling me the corrct lengh to get thanks