Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Wellcraft V-20 Forums > Repairs

Reply
 
Thread Tools Display Modes
  #1  
Unread 01-06-2008, 03:22 PM
spareparts's Avatar
spareparts spareparts is offline
God
 
Join Date: Oct 2006
Location: Raleigh, NC
Posts: 6,192
Default

I'll make it a little more tempting, its 75 and sunny here right now, and just the other day, I caught 8 trout from the dock, kept 5, big fish was 24", 3 released at 13 1/2 ( 14 inch minimum on specs here in SC). "Nothing could be finer than to live in Carolina"
Reply With Quote
  #2  
Unread 01-10-2008, 03:51 PM
LESTERUS LESTERUS is offline
Senior Member
 
Join Date: Jul 2006
Posts: 563
Default

sweet:

i had the same problem and ended up changing the engine to a v6 4.3, uses the same multiplication in the outdrive. however you can:

- take end the caps off the heat exchanger and clean the lines with a thin wire brush.
- check the raisers gaskets and make sure they are metal with close passage paper gaskets
- check the timing, the 470 is very sensitive if off timing just a little bit.
- make sure all hoses are straigth and disconect the hose that comes from the outdrive and make sure the drive's impeller is sending water out.
- replace radiator cap

good luck with that engine.!!!

Lesterus
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:19 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.