|
|
|
|
#1
|
||||
|
||||
Re: Trailer brakes ordered
Good selection on those components, Frayed..that's the exact combo I've had in mind...I've already got the 6600 actuator and likey a lotty ... READ THE INSTRUCTIONS that come w/it...you have to prime the DAMPER inside the unit from the master cyl...easily done, but a must ...
You can GRAVITY BLEED ... once all is installed, RAISE the tongue as high above the axle as you can ... this takes some time, but easily done if one-man install ...fill the reservoir slowly... and watch...you'll see bubbles burpin' to the top as the fluid finds its way thru the systyem...as it does, refill the reservoir each time ... The 6600 has an access hole in the top to apply pressure to the master cyl ... check the pressure as you go and eventually it'll be as tight as it gets... ;) ... Once bled, prime that damper and refill reservoir ... then go boatin'!! ... ;D ;D ...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
