|
|
#20
12-17-2006, 09:57 PM
|
||||
|
||||
Re: water in the oil
Well guys I found out what my problem is. I took the intake off and with some pvc coupling and a brass fitting I hooked the water hose up to the block and I found the BLOCK was cracked.
Thanks to spareparts & skool. I had pin holes all down the left side of the motor (bottom of the water jackets from front to back). I picked at them but it doesn't appear to be from rust. It almost seems to be a cast line in the block. I've never seen this before on a block. Does anyone know if this is a condition that happens to these 305 blocks?
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
|
|
Threaded Mode