21 FT Project Boat Part 1 Getting Close

[Skools Out]

clean out all the old wood then get either west system epoxy or MAS epoxy and mix it to harden slow. smother the new wood bottom and sides with epoxy then pour some in the transom hole and use a small roller to get the glass wet inside. then drive the new wood in and clamp at the top several times. wait about 3 days till it's dry and then cap the transom with new glass. it's not to hard. best is to use an electric chain saw without bar oil. that way nothing to cause the epoxy to delaminate.if you were to cut through the out side of boat it will not hurt except the paint job. but if so just glass ove the cut after you get the new wood in.