98 Johnson 200 Ocean Runner won't trim up

[Striper80]

I have a 98 Johnson 200. Earlier this spring the tilt/trim was working fine. I had to pull the engine off to remove a bolt that was sheared off on the upper part of the engine on the steering arm. When I reconnected all of the wires and controls yesterday the engine will only go down. I only hear the one relay clicking to make the engine go down. I swapped the relays and I got the same result. I checked all the connections and everything is connected. I was able to raise the motor to go up by putting voltage directly to the motor. I'm just wondering if anyone has any recommendations where to start my diagnosis?