|
|
#2
05-23-2014, 09:39 PM
|
||||
|
||||
It's not that hard to do most of a TRANSGO HD2 shift kit without pulling the trans. Keep in mind with a programmer you may want to see if you can put the trans settings in the PCM back to stock to keep from getting to hard of a shift with a shift kit in it. I personally prefer modifying the trans VS doing it in the programming, but don't ddo both unless it is setup for it in the programming. Not sure if the hypertech changes the shift firmness or line pressure, but it would be worthwhile to check and see.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
|
Threaded Mode