I spent a while trying to decide on my bracket design. I wanted the most flotation yet also wanted the most for performance potential. I liked the Hemco brackets how they have a v bottom yet I like the stainless because of their flat bottom that swoops up. So I decided onba hybrid design. A 13" pad that then follows the bottom angle up. It is 3" off the bottom on the angled sides and 4 5/8" off the bottom at the keel to the pad. 4 5/8" is the height from the keel to the first strakes. Then I had to decide on how tall to make the bracket. Spare mentioned to make the tub as tall as possible. But it did not look right with the motor cut out. It looked out of proportion. UNTIL I slid a piece of plywood over the cutout. Then it looked good! The outside of the tape is my final bracket outline. Still have to decide whether to make it swoop up or not.
__________________
1983 V-20 capsized. . . . in the garage.
|
10-25-2012, 10:53 PM
Threaded Mode