|
|
#3
06-13-2012, 06:58 PM
|
||||
|
||||
Phat, i purchased a dowloadable manual for the 1990-2000 2.5-275 Mercury/Mariner outboards, it was $8. If anybody wants, i can email you a copy of the manual, (i think??)
Still trying to verify some of the wires. I know one of these wires has to be for a warning horn for overheating, low oil etc. I did purchase the wire harness yesterday. It makes it much easier starting and killing the engine. So far i have not had to use the choke, it turns over for a half second then fires up, even after sitting all night. Also i ordered a new in box Mercury Commander Gen II binnacle control for $275. Now i need gauges, key switch, kill switch, warning horn, Teleflex Xtreme cables, and a hydraulic steering support shaft. Should i worry about the kill switch? I have never worn one, when on the boat with other people. But i have a feeling i will be doing alot of fishing by myself. On a side note, i can't find the trim sender on this motor. Is it a different design than the Johnson? On a side note, i don't think i have a trim sender on my motor. I can find one anywhere.
__________________
1983 V-20 capsized. . . . in the garage. Last edited by jasoncooperpcola; 06-13-2012 at 07:44 PM. Reason: trim sender 
|
|
|
Threaded Mode