Cylinder heads are off. I think the water got in around the bottom cylinder on the starboard side and/or the thermostat on the same side. There was pitting on the heads, but not on the block. My hope would be to clean and rebuild, I guess have the cylinder heads machined until smooth.
In the previous thread on this subject, someone suggested that if the crankshaft was rusted, I would be better off with a new powerhead.
http://www.wellcraftv20.com/communit...t=16993&page=3
Now that the lower unit is off, I'll try again to lift the powerhead tomorrow.
01-20-2012, 09:05 PM
Threaded Mode