Quote:
Originally Posted by jasoncooperpcola
I just ordered my trim tilt motor for my 85 Johnson 150. Getting ready to install it, is there anything i need to watch out for? I assume i just bolt the new motor on and top off the trim tilt fluid i lost. Correct? I cleaned some paint chips out that fell into the hole today and the filter and gasket came up, but i didn't see which way it went. Does the filter side of the filter go up or down? And does the gasket go on top of the filter or below it?
|
This is just a guess, but based on the picture that you submitted, it appears that the gasket goes on the top of the filter basket as shown in the picture. My reasoning is that the ID of the gasket matches the OD of the projecting flange on the basket. Plus, it looks like the thickness of the gasket matches the height of the flange on the basket. As to what the orientation is of the basket/flange unit, I'd look at where it came out from and see if any of the tabs on the basket or the gasket matched anything inside the unit. 
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer
1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer
1996 V21 w/1993 200HP Mercury on a Shoreline Trailer
All towed by a 5.7L Hemi Durango.
If God didn't have a purpose for us we wouldn't be here, so
Live simply, Love generously, Care deeply, Speak kindly.
(Leave the rest to God) 
Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless.
|
08-16-2011, 09:05 AM
Threaded Mode