'74 v-20 transom
recently bought this boat, great ride, good layout. 140 johnson puts it on step just fine. one prob, i noticed the transom was a little soft, tho it doesn't flex under use. anyway, i pulled the aluminum angle on the aft top edge (not standard i think) and there is an open seam there along the entire top. prying it open a little, i found what was once plywood inside is now oatmeal. i believe i'm going to have to cut out the aft transom face to get to all the rot and rebuild. my question is---where to cut? i was thinking about 1"-2" in from bottom and sides. ANY SUGGESTIONS WILL BE GREATLY APPRECIATED. mike
|
Threaded Mode