RR, The hull thickness appears to be about 3/8. 12:1 would be 36/8 or 4 1/2 inches. Are you saying to grind from 0 to 3/16 inch into the hull over 4 1/2 inches on the inside and fill with cloth and repeat on the outside? In other words, half the thickness in from each side? As it will not show inside i was under the impression I could overlay the whole area (8-12 inches out from crack) to around 3/8 or 1/2 thick and then epoxy putty from the outside. Will this not be strong enough? I appreciate all the help. Also I'm having trouble finding pics of a step by step repair. Any one have a decent link?
Thanks as always
|
10-18-2010, 04:00 PM
Threaded Mode