Transom and floor repairs

[bacchus60]

It has taken a long time to get this done mostly because the winter weather in Bermuda has been terrible this winter. However saying that I got most of the wood out of the transom using 3 different chainsaws, a 16" electric, a 18" gas and a 20" gas. Unfortunately I could not get it all but was down to good wood for the most part. This took longer than I anticipated; to those that got all the wood out you are superstars, I don’t know how you did that. I then used QuikPoly (thanks to THEFERMANATOR), this stuff is amazing it pours like water soaks into the wood and makes it bullet proof. I just poured it into the transom and then used a long handled brush to spread it all over the wood that was left, it took about a gallon of the stuff. I used the QuikPoly for two reasons; one to make the wood that was left stronger but also as I believe that the Arjay would bond better to the resin saturated wood better than the wood itself. Then it was on to the Arjay pourable compound. This stuff was also easy to work with (Get several cheap funnels), as noted from others it is a two man job. I did block up every hole, I used a mixture of silicon and then taped it with Gorilla tape; even with all of that though we had a hole we didn't know about nor could we reach. We used a hair dryer to get the leak area to set up faster and then pulled the entire leaked compound out, it was easy. Just a note here initially I only ordered 5 gallons but ended up using 10 so the point being make sure you measure and calculate exactly what you need. So now the transom is rock solid. I will have a link to pictures shortly.

Does anyone know where I can get floor hatches made; a couple of mine are cracked?