thanks nymack. I could of used some help yesterday. I glassed in the other two bulkheads. They were a little harder because they are below the floor that is still attached to the boat. When in place there is only 3/4" clearance between them. The way I apply fiberglass is I put the cloth on a piece of cardboard,completely wet it with resin. Then pull it off the cardboard and put it in place on the boat. It was pretty challenging pulling this giant sheet of wet woven roving through a 3/4" slot but I did it. It turned out pretty good,so far. My wife has to work till 3 today so I have some time to kill. Maybe I can get some more done today.
|
01-09-2010, 08:54 AM
Threaded Mode