More to come on this project....Fly has the tank DONE and now we need to play around with the aerator placement before gluing it in place. It comes with suction cups but I can't see those holding for more than a minute....I figure we'll use the suction cups to test the placement by putting a dozen or so shad in the tank and see about where the discharge should point. Chime in here Reel but I'm assuming place it off center to get a "swirl" going. Also not too close to the side such that they jam up and hurt their little noses. Once the optimal placement is found I will glue it in place with aquarium glue as Reel suggested.
P.S. Went jug fishing over the weekend. Only 8 jugs and 8 channel cats. Biggest went 8 ish lbs. Good times!
08-10-2009, 02:37 PM
Threaded Mode