Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Wellcraft V-20 Forums > Repairs
Register FAQ Community Calendar Today's Posts Search

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Unread 04-03-2009, 07:29 PM
ZAK ZAK is offline
Junior Member
 
Join Date: Dec 2008
Posts: 7
Default evinrude wont idle

The other day I took my v out fishing and I had some engine trouble. The boat ran great on the way out to the fishing spot. When I went to start it to move to another spot It took awhile to get it started and it did not want too stay running. I had to hurry up and throw it in gear and give it throttle then it ran fine . When I slowed down to idle it started to run rough and then stalled.I repeated this 2 or 3 times with the same outcome. I took the plugs out and they were dripping with gas.I put a new set of plugs in and still had the same problem. When I took them out they to were covered in gas.When I run it with ear muffs and hose it will idle (a little rough) but will not stall.Did a compression check and all cyclinders were at 110.My vro is not hooked up i am running pre mix.I cleaned all of the carbs,all new fuel lines,filter and gas.Please help I cant figure this problem out .The motor is a 1992 150 evinrude and like I said at full throttle it runs like a champ.Thank in advance for any advice that you might have.
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:02 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.