Floor repair

[spareparts]

one of the best ideas I've seen for hiding the seam from a repair is to leave a nice seam across the area like it was made that way, kinda hard to describe but if you've ever noticed on some nonskid decks, it looks like thay have partitioned off several areas with a smoth liine separating the nonskid ( ike around where the in floor tank is ). Well make your cuts so you can duplicate the seam on the other side so it looks like its supposed to be there. Just think ahead before you cut,lay out straight lines and when you done, just gel the area where the cut was. I'll take a picture if I get near a boat that has been done this way