|
|
#8
03-27-2019, 10:23 PM
|
||||
|
||||
The vinyl siding (maybe double it if it needs to be stiffer) sounds hopeful. I don’t know what it would cost but a sheet metal shop could shear some strips of stainless steel and punch holes for the screws if it’s too hard to drill - I’ve seen stainless that was impossible to drill and some that wasn’t bad - the shop would know.
__________________
 Scott, Portland, OR '85 V-20 I/O, Merc 170
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode