Rotor assembly not fitting all the way back onto spindle ?
New rear bearing fits all the way onto trailer spindle......rear seal fits over all the way onto spindle....BUT with rear seal tapped in.....the rotor won't go all the way back onto the spindle.
Maybe I tapped the race wrong ? Thought done correctly, but maybe I had the thicker side of race facing the wrong way......
Not sure till I pull the last wheel, compare each section, make sure all parts match up and try again.....
OR.....did the new real seal shrink up a bit when tapped in ?
I tried tapping the rotor on with wood block and hammer but it didn't move at all.
|
Threaded Mode