Measured and the tabs are 8x12. One of them is a little slower than the other, air in the lines? I wont be mounting them until after the bracket and painting. I was thinking about drilling oversize holes and then filling them with thickened epoxy. Then redrill the epoxy for the screw? Or should I just drill the hole fill it with epoxy then drive the screw into wet epoxy? Either way I will be going into a fresh transom and I want all my work to last as long as possible.
Also what is the distance from the top of the hinge to the bottom of the hull?
__________________
1983 V-20 capsized. . . . in the garage.
|
09-07-2012, 04:40 PM
Threaded Mode