|
|
#11
08-13-2011, 11:37 AM
|
||||
|
||||
Boron
Yea I have heard that about Boron. I was going to look for a different block. But, as you can see from the pictures this motor already has .020 over pistons. It must already have been bored or sleeved. It looks like I dont have a choice but to sleeve it and not run it to hard. Is there one sleeve that is better than the next? Any suggestions?
Last edited by Wolf; 08-13-2011 at 03:49 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode