Wellcraft V20 Community

Go Back   Wellcraft V20 Community > Wellcraft V-20 Forums > Repairs

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Unread 08-11-2009, 09:09 AM
THEFERMANATOR's Avatar
THEFERMANATOR THEFERMANATOR is offline
God
 
Join Date: Dec 2006
Location: Zephyrhills Fl
Posts: 7,206
Send a message via AIM to THEFERMANATOR
Default

Center of the engine on top behind the flywheel under the power pack lies the regulator. You have to remove the power pack and take part of the harness off to lay that cover over and then 6 bolts and she comes out. Sounds like she's shot though as mine with twin batteries will still hold almost 14 at idle in gear in the water and never goes above 14.8. I believe 15.2 is the point at which they are said to be bad. I would still check all the connections at it first and make sure it's getting a good battery voltage reading off of the purple wire at the strip under the pack as that wire is the one it uses to set voltage off of. Also make sure that the bolts on the pack are making a good ground contact because without a ground it will run whatever voltage it will hit with a 35 amp charge.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR

2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD

AND THE PINK JEEP!!!! R.I.P.
http://www.wellcraftv20.com/communit...ad.php?t=11664
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:00 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.