Engine Trouble

[csvencer]

I was shocked by the 0 compression as well, hence the reason I did it a couple times to make sure it didn't just stop working. At this time I am looking at getting a rebuilt powerhead, short block, for about $1900. I got one quote for just that cylinder at $1800 which made me start looking at a new block or rebuilding this one completely. A completly dressed powerhead will run me about $3200 so I think the short block may be the way to go. My only concern with that is how do I know the VRO pump isn't still messed up for that cylinder? I know it works as if it had completely died I would have had more than one cylinder get fried, but how do I ensure this won't happen again with a new block...??? I am also looking at a entirely new motor (new to me) as I have found late 90's-early 00's 150/175's for about $3500-$4500. I could then part out the johnson to recoup some of the cost. Any ideas on what I could get if I pieced it out? Thinking anywhere from $1000 to $1500 as everything from the lower unit up is good except the damn cylinder. Thoughts???

-Svence