if you still arent getting 12v and dont want to rip all of the wires out and start from scratch replace the blade connector on the switch and the connections at the lights. 99% of the time corrosion with cause the voltage drop. also you messed up when cutting the black loop you need that to be connected it gives power to each bank of the 6 way switch. do this. connect the middle wire on one side directly to the wire that is suppose to bring voltage to the light and test in the front. if you have 12v to the front then its a bad switch or bulb. if no 12v then you have a ground issue.
|
05-15-2008, 10:04 PM
Threaded Mode