Steering Troubles

[steplift20]

hey mush i know exactly what your going thru, when you pump grease into the shaft it only comes out of the bottom right what i did was i bought a flush mount grease fitting and a nozzle the fits it i drilled a hole about 1 to two inches from the top and thats how i got grease to flow to the top i used penetrating oil pb blaster heat and it only worked for a little while put a grease fitting near the top and becareful when you drill do a little at a time and check that it did not go thru the shaft
i was going to use a reg grease fitting and had it on but when i turned the engine it hit so watch were you are putting it you can use a reg one just make sure the motor doesnt hit it when its turned all the way to take the wheel off try hitting the center with a hammer as you are pulling on it
when it comes off your going to say why was that so hard its a tapered shaft and it should come right off