![]() |
|
#1
|
||||
|
||||
|
.....inside the float bowl of my Rochester carb. 3 times now the jet/port whatever ya call it that the needle valve shuts off by the float has loosened up dropped down a bit *and caused the bowl to starve for fuel, causing the motor to only idle. I've tightened it up real good but, I 'spose the vibration is too much. I tho't I'd put some threadlock but, dunno if the gas will dissolve it post haste. Any thoughts? TIA
__________________
Doug aka "Hammerhead" Jensen Beach, Florida '77 V-20 165 I/O |
|
#2
|
||||
|
||||
|
I know they make thread locker stuff that is impervious to solvents but don't know if that is how you are supposed to correct that.
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW |
|
#3
|
||||
|
||||
|
well it might work? I hate to see you add something in there and it melt and clog something else!!
How about getting a star washer?? They are thin and that just might do it for you? Its only 1/16 inch Just a thought.
__________________
1986 V20 ![]() Old Fishermen never die, we just SMELL that way!! |
|
#4
|
||||
|
||||
|
Hammerhead, the little bit of Lok-Tite you'll use on that screw won't have any ill effects...after 3 times (this'll be the 4th), I'd put LT and a star-washer if it'll fit... ;D...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha |
|
#5
|
||||
|
||||
|
ThanX guys.....didn't think of a star washer :-[ I'll get one tomorrow.
__________________
Doug aka "Hammerhead" Jensen Beach, Florida '77 V-20 165 I/O |
![]() |
|
|