|
|
#11
|
|||
|
|||
Replaced the 3 - way valve, is there a way to check the valve to see if it was bad?
__________________
love to fish 
|
|
#12
03-29-2022, 06:56 PM
|
||||
|
||||
|
blow in it from each direction, with your finger over one end, should allow air to go thru from the end that didn't have a hose on it
|
|
#13
03-30-2022, 08:33 AM
|
|||
|
|||
|
I did that and the larger holes the air goes thru no problem but the smaller hole , I think it might be were the oil line gets hooked to doesn't flow thru. I check the old and new ones the same way and they seem the same. I wish I knew how to post a picture of it.
__________________
love to fish
|
|
#14
03-30-2022, 10:06 AM
|
||||
|
||||
|
close one end that the oil line goes thru with your finger, blow thru the end that didn't have a hose hooked to it, air should go thur
|
|
#15
03-30-2022, 05:06 PM
|
|||
|
|||
|
Spare, it has three hole outlets one small one that I think is hooked to the oil and two larger hole outlets
The larger outlets / hole air flows thru no problem The smaller outlet/hole that the oil hose goes to has no air flow at all even when I close one larger hole and blow nothing goes thru the smaller one Is that good? I don't understand what the oil outlet hole does? If no air flows thru than how does the oil flow thru? I guess that's why you mechanics get the big bucks, I would love to learn how it all works but I'm retired now and just want to fix what I have.
__________________
love to fish
|
 |
|
|
Linear Mode
